This video shows how to use a Borg & Overström T3 Tap System.
To dispense water from a T3 Tap System follow the guide below:
Model shown with chilled, sparkling, ambient and hot water options. Other models may vary.
How to dispense water
- To dispense water press desired water option button and hold. Release to finish dispensing.
As a safety feature, an unlock button is included to prevent dispense of hot water by mistake.
- For hot water press and release unlock button then immediately press and hold hot water button.
Illuminated indicators
You may see your icons pulsating. If the chilled and sparkling icons are pulsating, that means the chilled temperature is too high and the compressor is actively cooling your water.
If your hot icon is pulsating, that means the hot tank is heating your water.
Additionally, when the hot tank is heating up, the lock icon may be off. This is to prevent hot water being dispensed until the water is hot enough.
Your T3 may have an Ecomode feature enabled. This puts the dispenser into a sleep mode if it has been idle for 2 hours or 6.5 minutes in darkness. If you find the dispenser in Ecomode, pressing any button will wake it up again. If the dispenser has been in Ecomode for some time, you may need to allow five to ten minutes for the dispenser to reach temperature again.
Ecomode can be disabled if desired, please contact your Borg & Overström supplier for instructions should you wish.
- EcoMode: EcoMode will activate in the instance of dispense inactivity or low light levels, identified by the EcoMode symbol being illuminated.
- Chilled and sparkling water icon pulsing: Unit is chilling down.
- Hot water icon pulsing: Hot tank heating up.
- Warning symbol: 'Warning triangle' will illuminate and flash when fault is present.
- Unlock icon unlit: Hot water unavailable, temperature below 80°C
