This video shows how to use a Borg & Overström E6 Water Dispenser with Measured Dispense.
To dispense water from an E6 water dispenser with measured dispense, follow the guide below:
Model shown with chilled and sparkling water options. Other models may vary.
How to dispense water
- To dispense water press desired water option button and hold. Release to finish dispensing.
- To dispense using the measure dispense feature, press either of the measured dispense icons and then press the chilled or sparkling icon. You have ~2sec to select chilled or sparkling water after touching the measured icon.
To reset/set the measured amount:
- Press and hold the half or full measured icon for ~20sec until you hear a long audible beep. The icon will then flash on and off to show you that you are setting up that dispense option.
- Press and hold the chilled icon until the desired amount is dispensed. Note: The measured icon will still flash during this dispense.
- A double beep will be confirmation that this measurement is then stored in memory and will dispense the same quantity of chilled or sparkling water. If the incorrect amount is dispensed, start again.
Set back to factory default setting:
Default values have been set to 350ml and 700ml. To restore default settings, tap the chilled icon 12 times and hold on the 12th. You will hear 2 beeps, wait 2 seconds and the unit will reset.
Illuminated indicators
You may see your icons pulsating. If the chilled icon is pulsating, that means the chilled temperature is too high and the compressor is actively cooling your water.
Your E6 may have an Ecomode feature enabled. This puts the dispenser into a sleep mode if it has been idle for 2 hours or 6.5 minutes in darkness. If you find the dispenser in Ecomode, pressing any button will wake it up again. If the dispenser has been in Ecomode for some time, you may need to allow five to ten minutes for the dispenser to reach temperature again.
Ecomode can be disabled if desired, please contact your Borg & Overström supplier for instructions should you wish.
- EcoMode: EcoMode will activate in the instance of dispense inactivity or low light levels, identified by the EcoMode symbol being illuminated.
- Chilled water icon pulsing: Unit is chilling down.
- Warning symbol: 'Warning triangle' will illuminate and flash when fault is present.
